How-To Swap Mods On Mathews Vertix / VXR

HOW-TO SWAP MODS ON MATHEWS VERTIX / VXR

As we are heading into the spring and summer season, and as I prepare for a Total Archery Challenge event (assuming we still have it with all the Covid-19 mess), I need to increase the number of arrows I am shooting on a daily/weekly basis. My setup is a 75lb Mathews Vertix at the current time. In order to shoot the quantity of arrows I want; I need to reduce the draw weight. I can shoot the 75lb draw fine, but for a limited number of arrows before fatigue starts to set in. Hopefully this How-To Swap Mods on a Mathews Vertix / VXR bow helps you with the switch.

HOW-TO SWAP MODS ON MATHEWS VERTIX / VXR

I ordered a 60lb mod and in this how-to post I am going to walk you through swapping the mods. It is easy and you donโ€™t need a bow press. If I can do it anyone can.

Tools Required: 5/64 Allen Head Wrench (My Cabelaโ€™s branded Allen wrench combo had this size)

To swap out the mods on each cam you only need to remove two screws (silver in the picture).


HOW-TO SWAP MODS ON MATHEWS VERTIX / VXR
  • Step 1: Lay the bow down on a flat surface with the two screws facing up.
  • Step 2: Break the screws free by turning counterclockwise ยฝ turn.
  • Step 3: Remove pressure from the cable on the mod by pulling the cable toward the bow body (Pictured).
  • Step 4: Remove two screws and set aside.
  • Step 5: Remove existing mod and replace with new mod.
  • Step 6: Replace screws and tighten.
  • Step 7: Repeat on the other side, top or bottom depending on where you started

Thatโ€™s it, simple, easy and quick.I posted a video on YouTube of this mod switch if you prefer video direction.

How-To Swap Mods On Mathew Vertix/VXR

As always, reach out with questions & comments 1strutcontact@gmail.com

Cheers,

#elder

Leave a Reply

%d bloggers like this: